ITECH Active 2 Smartwatch Fitness Tracker User Guide
ITECH Active 2 Smartwatch Fitness Tracker User Guide
SAFETY AND SKIN CARE
- Regularly clean your smartwatch with a damp cloth
- After cleaning, always dry your watch thoroughly
- Keep your wrist free of any cosmetics, dirt and oils
- Keep your watch loose enough to allow some air circulation (wearing a watch too tightly can cause skin irritation)
- After workouts, we strongly suggest cleaning both the watch and your wrist
- Should you experience any skin irritation, discontinue wearing for at least several days or until the irritation discontinues
- Adults with eczema or any skin condition should consult a physician before wearing the watch.
CHARGING YOUR SMARTWATCH
Your smartwatch may be in low battery mode when you first receive it. We recommend charging your smartwatch fully before first use. Battery life and charge cycles vary based on usage.
- Plug the charging cable into the USB port on your computer or a UL-certified USB wall charger.
- Connect the smartwatch to the charging cable as shown below. A charging screen appears on the watch to indicate that your smartwatch is charging
Your smartwatch takes about 1-2 hours to fully charge.
SET UP YOUR SMARTWATCH
To set up your new smartwatch, download our free mobile app by scanning the QR code below. Open the app on your phone, tap the watch icon on the upper right and follow pairing instructions. Once finished, the correct time and date will appear on your watch. NOTE: Pairing must be done using the mobile app and not with your phone’s native Bluetooth.
REPLACING OR CHANGING THE WATCH BAND
To remove the existing strap:
- Turn the watch, face down
- With your finger pull the pin to the left and gently pull the band away from the watch. The band should easily come detached from the watch.
Attaching a new band:
- Line up the steady pin with the hole on the base of the case.
- While carefully holding the band in place, pull the lever on the band to retract the pin down and position the band against the case to line up the pin.
- Release the lever so the pin snaps in place.
- Repeat these steps for the other strap.
FCC STATEMENT
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
WARRANTY
This limited warranty gives you specific legal rights and you may also have other rights, which vary from state to state. For all warranty information please visit: www.itechwearables.com/warranty FCC ID: 2AS3PITACT2 SYSTEM REQUIREMENTS (Android 9.0 and up) (iOS 13.0 and up) Make sure your phone’s Bluetooth is turned on and enabled. For user manuals, please visit support.itechwearables.com
Support
DO NOT RETURN PRODUCT TO THE STORE FOR SUPPORT
FOR TECHNICAL ASSISTANCE, WARRANTY AND CUSTOMER SERVICE, EMAIL: [email protected]
